ODrive Pro (Draft Copy)
ODrive Pro (Draft Copy)
Reliable, high performance in 5 x 6.5cm
Locking connectors for wire harness
Dual absolute encoder support for precise load positioning and instant cold starts
Up to 5kW peak, 3kW continuous power with appropriate cooling
Shared software architecture with all current generation ODrives, including Web GUI support
CAD - Software Documentation - Configuration GUI
Specifications Below
1 - $ 229.00
10 - $ 219.00
40 - $ 214.00
100 - $ 209.00
400 - $ 204.00
1000 - $ 199.00
For 40+ please use the RFQ/Order form.
Must read info:
Shown with enclosure or heat spreader plate: recommended, sold separately.
The ODrive Pro does not have a brake resistor driver and should hence be used with a battery or a regen clamp module.
USB and DC input may not be connected at the same time, unless you use a USB isolator.
Browse encoders, motors and accessories that go with ODrive Pro.
Electrical Features
CAN 2.0B @ 1Mbps with simple protocol (CAN-FD Firmware Coming Soon)
Supports offboard quadrature, hall, SPI, SSI, and RS485 encoders. BiSS-C support coming soon.
Incremental encoders and hall sensors have on-board input filters
Isolated CAN, UART, Step/Dir and PWM control inputs
Locking IO connectors with a diverse and flexible feature set.
High quality encoder magnet available here.
